Shower Curtain Rod Keeps Falling

Any ideas on how to make the rod stay up long enough for me a take a shower.

Shower curtain rod keeps falling. This one stayed up for about a day and now it won t stay put for longer than a couple of minutes. You can pick them up in most hardware store. Poorly installed tension rods. Every few days the tension rod holding my shower curtain up was falling down.

59 answers hoffman deanne. There is a way to make it stay. I have an expensive rod so that is not the problem but no matter it keeps slipping on the tile after use or pulling curtain. I m not sure what the deal with lowes is but they did not have any shower curtain rod holders in the shower curtain section.

Buy a small package of 1 self adhesive felt pads 48 ct. I use a bit of rope caulking get it nice warm and sticky then put up shower rod stuff the rope caulking around the pole and a double portion under it forming a cup shape. Anyone have any ideas as to how to keep a tension shower curtain rod up on tile without using screws. My shower curtain would fall down.

On sep 2 2016. It drove me bananas. How to keep shower curtain rod from falling down. Hang the shower curtain rod at an angle with one end several inches higher than you want it.

Our shower curtain rods were always falling it was a combination of having to have extra long rods due to the width of our shower and having boys that are overly aggressive with the shower curtains always the boys. This fix cost around 5 and took less than five minutes. Easy fix falling shower rod. Alot of the curtain rods when installed over tile will eventually slip due to the slickness of the tile for a simple asolution you could simply buy a pack of velcro and stick small pieces to each end of the rod and the tile small 1 2 inch pieces this will hold it there.

Sells for 3 at big lots peel of the backing and stick one on either sides of the tile wall where your rod will go have the rubber ends of your rod go to each felt pad. Tension rod shower curtain issues. The state of the wall tension rods can fall if the walls of your shower are dry. Slowly slide that end down until the rod is hanging straight.

The felt pads keep it from sliding futher down the tile wall. Has anyone found a way to make it stay in place. Use the very inexpensive closet rod self adhesive fastners. I suggest looking where they sell the 3m self adhesive.

I found these in the closet isle. Dry wall causes the rods to become. Reasons why the tension curtain rod keeps falling or slipping 1. If the walls on either side of the shower are drywall you may not be able to tighten the tension rod enough without cracking the walls.

The new rods twist and lock in place but even though i get it on tight it occasionally just crashes down. I wondered at first if the black felt pads i used would be visible but once they are compressed you can t see them at all. The walls are tile and it s a rental so i can t drill into them. Why didn t i do this before.