Glue Shower Rod To Tile

Can anyone recommend a good type of glue to use for this application.

Glue shower rod to tile. Slowly slide that end down until the rod is hanging straight. Step 1 clean both the surface of the tile and the surface of the metal. Stick to stay shower rod holders supports by paw international rated for 50 pounds. Installs in as little as 30 seconds without tools no screws no shims no drilling or cutting fits shower rod with end caps up to 1 1 2 diameter works on ceramic tile fiberglass and glass shower walls.

How to glue metal on tile by. So you can go the more expensive route and risk damaging your tile by installing a permanent rod or you can go the cheaper and easier route by installing a tension rod therefore not risking your tile in any way. I have one of those shower curtain rods that has the end caps that you screw into the wall and then hang the rod from the end caps. What type of adhesive is recommended for gluing metal brackets for a shower curtain rod to ceramic tile.

I think just a good coat of silicon caulk and then tape it until it cures would work. I was thinking maybe liquid nail or something similar that is waterproof. No drilling required adjustable shower bar for tile stone glass metal wood concrete brick and most plastics by nie wieder bohren works on rough or smooth surfaces. Hang the shower curtain rod at an angle with one end several inches higher than you want it.

I used titebond s hi purformer glue gun to attach some tile to tile but it was granite and somewhat porous. Uses a german engineered. It might look weird if you don t do something with the screw holes unless they are behind an. Some of those are really sticky.

Problem there is that you d have to buy the gun which is not cheap. I really really really don t want to drill eight holes four for each end cap into my brand new tile shower walls. If you have porcelain or ceramic tile in your shower you are probably hesitant to damage it any way while putting up a shower curtain rod yet without a rod you risk having a mini flood in your bathroom every time you bathe. It s the same idea as the chin up bars that mount in a doorway.

Any comments and or. Before using any adhesive to secure a shower curtain rod i think you d have more success keeping it in place with an expanding or screw type rod. I though gluing the end caps onto the walls might be a better way. The rubber stops at each end of the rod prevent mars and wall damage.

Also i don t want the ceramic to be damaged if the brackets need to be removed. Use a solution of soap and water to remove. The rod is an arched type that bows out to make the shower stall a little more roomier. The felt pads keep it from sliding futher down the tile wall.

I wondered at first if the black felt pads i used would be visible but once they are compressed you can t see them at all. I ve seen them turned so tight the tile cracked. Whether you re attaching a metal towel rack to a tile wall creating an art project that involves the two materials or completing some type of home improvement project gluing metal to tile is a simple task that involves little preparation. Attaching metal to tile using glue prevents you from having to drill holes into the materials.